lordpil's blog


_digital_: itll depend on the board house
they might just default to their smallest edge router, which may add a bit to the cost

Posted by renesis at 13:19 | permalink | 0 comments


it depends how your shit is setup
if theyre 3" square and you specify vscore and the panel is under their standard panel size, should be cheaper
if theyre milled edge, complex shape, they might end up being more
then ask more than one board house how they want to do it
make sure the notch is machinable
inside radius are big
else they gotta like punch that shit or something
yeah thats not great for paneling
np
i would radius those inside corners or what you end up getting will be random
most likely will be inside radiused anyway
ask them about that too
anyway, bbl

Posted by renesis at 12:46 | permalink | 0 comments


Top | Add to Technorati Favorites


© 2007 lordpil.   XHTML 1.0! CSS! Site design by GNAA  Blog Engine by pbx | MULTI2 | ian hanschen | lolwat