lordpil's blog


looks like repetier is based on reprap firmware?
Repetier-Firmware is a firmware for RepRap like 3d-printer powered with an arduino compatible controller. This firmware is a nearly complete rewrite of the sprinter firmware by kliment which based on Tonokip RepRap firmware rewrite based off of Hydra-mmm firmware. Some ideas were also taken from Teacup, Grbl and Marlin.

Posted by renesis at 13:30 | permalink | 0 comments


what hardware?
wonder if its just grbl stuff
right im just wondering whats turning the gcode into motor controls

Posted by renesis at 13:24 | permalink | 0 comments


net|: is this is a linuxcnc UI?
whats doing gcode interpreting and motion control?
shrug, no idea then, maybe 3d printer gcode interpreting and control is turnkey
this just uploads gcode and sends control commands to existing hardware interpreters/controllers?

Posted by renesis at 13:19 | permalink | 0 comments


Top | Add to Technorati Favorites


© 2007 lordpil.   XHTML 1.0! CSS! Site design by GNAA  Blog Engine by pbx | MULTI2 | ian hanschen | lolwat